Training course for PCB designing

  •      a Single, Two, Four and Multi Layer design
         a Circuit component creation in schematic library
         a Circuit design in schematic editor
         a Footprint for circuit component in PCB libraty
         a ERC (Electrical Rule Check) for entire circuit
         a Annotation of components and NETLIST creation for PCB editor
         a Board boundaries, Component placement and routing
             in PCB editor
         a Setting up DRC (Design Rule Check) through dialogs
             such as Net Classes and Net properties
         a Generation of manufacturing outputs like Gerber,
             NC Drill, masking and legends
         a Create Bill Of Material (BOM)
         a Report of other design parameters